The trace above is from a venue in Beaumont Texas where I worked with Classical Mystery Tour & the SOST. The pink trace represents the house left side of the PA. The yellow trace represents house right side. Obviously there is something wrong with the house left side of the PA. I was sent a text the night before the gig revealing there was a problem so I knew I had to deal with it before I arrived. Due to the tight orchestra rehearsal schedule & arriving from Lubbock that morning on a plane, I had to get thru a band sound check and then an orchestra rehearsal before I was able to measure the PA. The band typically does a last minute warm up on stage before doors open so I knew I could hear the band again but didn’t want to change the PA balance too much. I also didn’t have time to try to address the cause of the low end drop off with the house left side of the PA. I ended up using the console (Yamaha M7CL-48) parametric EQ to split the difference between the two sides.
INSERT SCREEN SHOT
Working for Texas Ballet Theater on “Peter and the Wolf – the children’s ballet”, I spent the last two days at the Mansfield ISD PAC. Huge place that barely gets used. The PA is made up of a stereo L/R JBL Vertec rig with subs at the top of the arrays. The balcony has it’s own (3) shorter JBL Vertec columns but that part of the venue wasn’t being used so that part of the PA was off. The venue also has curtains that block the balcony when not used so that helps the sound on the main floor. All in all, a fairly nice rig considering the venue gets used mainly for high school graduations. This gig was another reminder that being able to measure a PA is vital in this day & age. I could of EQed the PA based on listening to music & my own voice but measuring is simply a superior way of doing the work.
This capture shows that the house PA has excessive low / low mid content. Not a good thing. Especially when dealing with narration. Excessive low / low mid content for human voice makes it hard to understand the words.
If you set up your rig correctly, you can compare the input signal going to the console, the output signal coming from the console & the room response at the reference mic. After selecting the “pair” of signals you want to compare in the right order, you can see how well the compensative eq follows the room response at the microphone.
This is a capture of the original trace, the corrective eq trace & a measurement I made of the audio I/O. I have included the audio i/o measurement (green) because it helps explain the frequency & phase response of the console output. The low & high end phase drift & roll offs are an artifact of the audio i/o. Not the EQ itself.
With the compensative eq in place via the FOH consoles parametric eq, the end result is this which worked much better.